Move between the modes

Objectives

The simulator ticks each one as soon as the network meets it.

1. Type enable to reach R1#, then disable to drop back to R1>.
2. Type enable, then configure terminal, to reach R1(config)#.
3. Open interface GigabitEthernet0/0, then type exit. You are back at R1(config)#, one level up.
4. Open the interface again, then type end. You jump straight to R1#.
5. Go back with configure terminal and run do show ip interface brief. do lets a show command run from a configuration mode.
6. Type end, then read the whole configuration at R1#: show running-config.