TechNetBuddy

What the exam expects

Smaller areas, each worth knowing well: ACL types and rules, AAA, NAT and its scenarios, network services (DHCP, DNS, NTP, FTP, Telnet), and IPv6 addressing and static routes.

ACLs

A basic ACL (2000–2999) matches the source only; an advanced ACL (3000–3999) also matches protocol, destination and ports. Rules are numbered in steps of 5 and checked in order. A wildcard of 0 means one host. traffic-filter inbound acl 3000 applies one to an interface; on Huawei routers a packet no rule matches is permitted. Place a basic ACL close to the destination, an advanced ACL close to the source.

AAA and device access

AAA (authentication, authorization, accounting) lives in the aaa view: local users with a password, a service type (ssh, telnet, terminal) and a privilege level. user-interface vty 0 4 with authentication-mode aaa and protocol inbound ssh allows only SSH (STelnet) logins.

NAT

Easy IP (nat outbound 2000 on the outside interface) gives a whole LAN one public address with port translation. An address pool (nat address-group) gives several. nat static maps one inside host one-to-one; nat server publishes an inside server, either the whole address or one protocol and port.

DHCP and VRRP

dhcp enable, an ip pool with gateway, network and DNS, and dhcp select global on the interface make a Huawei device a DHCP server; dhcp select relay with dhcp relay server-ip forwards requests to one elsewhere. VRRP (vrrp vrid 1 virtual-ip …) shares a virtual gateway between routers; the highest priority is master, and tracking an uplink lowers it when the uplink fails.

IPv6

IPv6 addresses are 128 bits written in hex groups; :: replaces one run of zeros. Every interface has a link-local address (FE80::/10). Hosts can configure themselves with SLAAC from the router’s RA, or use DHCPv6. On VRP: ipv6 globally, then ipv6 enable and ipv6 address per interface, and ipv6 route-static.

Commands at a glance

[R1] acl 3000
[R1-acl-adv-3000] rule 5 deny icmp source 192.168.1.10 0 destination 10.1.1.10 0
[R1] interface GigabitEthernet0/0/0
[R1-GigabitEthernet0/0/0] traffic-filter inbound acl 3000
[R1] interface GigabitEthernet0/0/1
[R1-GigabitEthernet0/0/1] nat outbound 2000
[R1-GigabitEthernet0/0/1] nat server global 203.0.113.10 inside 192.168.1.10

Not modelled in the simulator: DNS, NTP, FTP, TFTP, HTTP and Telnet sessions are not simulated (NTP and log host settings are stored). DHCPv6 is not modelled. Only ICMP is filtered by ACLs in pings.