ACSE · OSPF

Alcatel-Lucent: OSPF on OmniSwitch

Three OmniSwitches in a chain already have their VLANs and IP interfaces. Run OSPF area 0.0.0.0 on every IP interface so PC1 can reach PC2. On AOS the OSPF software must be loaded before it can be configured, and the protocol, the area binding and each interface are all enabled separately.

ALE ACSE track · Alcatel-Lucent AOS · 5 objectives

Open in simulator More ALE ACSE labs

Objectives

The simulator ticks each one as soon as the network meets it.

Set the router IDs 1.1.1.1, 2.2.2.2 and 3.3.3.3 (ip router router-id).
Load OSPF (ip load ospf) and create area 0.0.0.0 on all three switches.
Add every IP interface to OSPF in area 0.0.0.0 and enable it, then enable OSPF (ip ospf admin-state enable).
Check show ip ospf neighbor: SW2 has two neighbors in state Full.
Ping PC2 (192.168.3.10) from PC1.

Start this lab